|
Engine: Three
port, two stroke.
Cylinders: Two.
Bore: 63mm (12bhp), 68mm (16hp).
Stroke: 56mm
(12bhp), 60mm (16hp).
Displacement: 350cc + 440cc (16hp).
Power Output: 12bhp + 16bhp.
Torque: 19ft/lb + 24ft/lb
Max.
Carburettor: Amal Series
200.
Fuel: Petrol/Oil mixture.
Fuel Consumption: 2/3 pints/hour
at cruising - 8.60 pints/hour
at full throttle (12hp) +25% 16hp.
Lubrication: Petrol/Oil mixture 40/1.
Cooling: Raw water.
Water Pump: Johnson F35B-8.
Sparking Plugs: AC-46 XLS, NGK-BP5ES, Champion-N16YC.
Engine Mounting: Flexible, on four sheer rubber
bobbins.
Maximum Installation Angle: 15 degrees.
Crankcase: Sea water res. alloy - fully machined.
Crankshaft Assembly: Four flywheels, shafts
and two crankpins pressed up into a complete assembly with connecting
pins.
Connecting Rods: Forged, with hardened and
ground big end eyes.
Big End Bearings: 24 uncaged rollers in two
rows of 12 for each big end.
Pistons: Lo-Ex alloy with narrow rings of considerable
radial depth. Oversize available.
Gudgeon
Pins: Needle
Roller Bush - running on hardened and ground Gudgeon Pin.
|
Cylinder
Heads: Sea water res. alloy,
fully machined toroidal form combustion chambers - large
water passages.
Cylinders: Close
grained nickel iron. Very large water passages.
Starting: 12 Volt through roller clutch. Emergency
hand start at front of engine (flat belt).
Battery: 12V
x 50/60amp.hour capacity (minimum).
Charging: 500
Watt Alternator.
Weight: 120lbs.
including Mtgs. and gearbox (54 kg).
Control Panel: "A" water
resistant plug-in flat panel with battery condition indicator, ignition
switch and charging warning light. "B" as above with rev. meter
and ammeter.
Ignition: Lumenition
breakerless ignition with high voltage discharge coil. Twin trigger back-up
system.
Remote
Controls: Single
lever throttle and gearbox.
Drive: 2-1
reduction through Hurth FNR gearbox (3-1 optional).
Propeller:
12"/13" x 10" Bronze R.H. fixed (folding
optional). 14/15" (16hp).
24 Month Guarantee: (from
date of purchase): provided your engine is installed to
normally accepted commercial standards Dolphin guarantees
parts of their own manufacture against faulty workmanship. ANY
CARRIAGE COSTS are on the account of the purchaser. Spark plugs, belts
and/or misuse or flooding are excluded.
|